What Is TPO Roofing? A Guide for San Antonio Building Owners

What TPO is, how it's installed, and how it compares with mod bit and PVC.

White TPO roof membrane with a flashed curb vent and a rooftop AC condenser.

TPO stands for thermoplastic polyolefin. It's a single-ply roofing membrane, usually white, that comes in wide rolls and is heat-welded at the seams into one continuous sheet. Along with modified bitumen, it's one of the two most common low-slope roof systems on commercial buildings in San Antonio, and it's what most owners are quoted when a flat roof needs replacing.

How a TPO roof is built

A TPO roof is a system, not just the membrane. On a typical replacement, the layers from the deck up are insulation board, often a cover board, and then the membrane. The membrane is held down one of two common ways. Mechanically attached systems screw it down with plates along the seams. Fully adhered systems glue it to the cover board. At the seams, a hot-air welder melts the edges of two sheets together. A good weld is stronger than the sheet around it, which is why seam work is where installation skill shows most.

TPO generally isn't laid straight onto a wood or metal deck. The insulation and cover board under it give it a smooth, stable base and carry most of the roof's insulating value.

Thickness

TPO is sold in 45, 60 and 80 mil thicknesses, and some versions have a fleece backing for extra puncture resistance. Thicker membrane has more material above the reinforcing scrim, so it holds up longer to UV and foot traffic. The right thickness depends on the building, how much rooftop equipment gets serviced, and how long the owner plans to hold the property. On most of our commercial replacements we install 60 or 80 mil.

Why TPO works in Texas

  • It reflects heat. A white TPO roof reflects most of the sun's heat instead of absorbing it. On a single-story retail center, where the roof is a large share of the building's envelope, that lowers roof temperatures and the cooling load on the space below.
  • Seams are welded, not taped. Heat-welded seams resist the expansion and contraction that come with 100-degree afternoons and fast cold fronts.
  • It's cost-effective. TPO usually costs less than PVC for comparable performance, which is why it's the default on so many apartment communities and retail centers.

The tradeoffs

TPO is a single layer, so a dropped tool or careless foot traffic can puncture it. Walkway pads around rooftop units help. Seam quality depends entirely on the crew, so a poorly welded seam can fail years early. Like any low-slope system, it needs drainage that works: water that sits for days after rain speeds up wear on any membrane.

TPO vs. modified bitumen vs. PVC

  • Modified bitumen is asphalt-based and goes down in multiple layers. It's tough and forgiving of foot traffic, and it's the other common choice in San Antonio. It's darker unless it gets a reflective cap sheet or coating.
  • PVC is also a heat-welded single-ply membrane. It costs more than TPO and resists grease and chemicals better, which makes it the usual pick for restaurants and buildings with kitchen exhaust on the roof.
  • Metal suits steeper or architectural sections more than true flat roofs. See our metal roofing page.

Replacing an old roof with TPO

If the existing roof is a single dry layer over a sound deck, TPO can often go over it as a recover, which costs less than a tear-off. Our post on recover vs. tear-off explains when that works. For the full process, from scoping bids to keeping tenants informed, see planning a commercial roof replacement.

We install and repair TPO roofing on apartment communities, retail centers and other commercial buildings across San Antonio and Austin, along with PVC, modified bitumen and flat roofing systems. Request a bid to have your roof looked at.

USA Home & Commercial
USA Home & Commercial Team
get started today

Still Have Questions?

Whatever you're dealing with, we're happy to take a look and tell you straight.